Wednesday Aug 17, 2022

How to Repair a Water Damaged Cell Phone

Learn how to repair a water damaged cell phone by following these simple steps. Don’t get frustrated if it gets soaked in water/ tea/ coffee/ other liquids? You can easily save it if gets wet if you follow these simple steps as precautionary first aid measures.

Most of the people don’t follow the basic steps to avoid a water-logged phone from getting damaged. The basic thing to follow is the procedure to avoid the damages on the circuit board of the mobile phone as it is what an engine is to a car. The main difference between mechanical gadgets and electrical gadgets in terms of repairing or fixing is that a mechanical gadget can always be repaired, while an electrical one cannot be repaired if its circuit board gets damaged. (This is because in case of mobiles, you lose warranty for a water damaged device and the service centers don’t provide a new mother board in such cases. Also circuit boards of mobile phones are not available in open market. You can also leran how to repair iphone reparatur cell phones at Alfa institute by mobile technology by joining their cell phone repair training course.

Steps to repair a water damaged cell-phone –

 

  1. Remove the battery: When your cell-phone falls in water, the first thing to do is to remove the battery immediately. ( This action prevents the circuit board from getting damaged as water is a good conductor of electricity. It spreads on the board and damages small components with the help of voltage coming from the battery). Don’t just switch-off the phone, as it will do no good if the battery is not removed.
  2. Dismantle your handset: Next step is to open the mobile phone with the help of a screw driver and just separate all the parts. Be careful and observe properly how you are opening as you will have to assemble the entire gadget again.
  3. Dry all the parts and the circuit board: Now dry the green-colored circuit board and other components completely with a hair drier or in open sunlight. Clean it using alcohol or spirit with a brush. This will prevent any corrosion of the circuit in the future.

admin

Leave a Reply

Your email address will not be published.

Back to Top